McCoys MoPop-Museum-Copy, Medical Scanner Parts KIT ONLY. HERO SET USED SCANNER TODD MUSTACIO YOUTUBE. INCLUDES ALL THE PARTS SHOWN GREEN-BACKGROUND PHOTOS AND AS LISTED BELOW.HOT ITEM AS FANCY-HIGH-GRADE WAND TRICORDERS MAY COME IN 2021. This were expertly machined out of aluminum. The body is hard anodized black aluminum and in exactly the size and details of the museum displayed prop. COMPLETE PARTS KIT: Crafted of machined aluminum, acrylic, two sets of hologram stickers, pin-stripe red tape, motor, three battery holder options, even the set-screw! NOW INCLUDES MOTOR AND BRASS GEARBOX WITH MoPoP STYLE MACHINED INNER ALUMINUM TOP-CAP ASSEMBLY NOW INCLUDES THREE SEPARATE LR44 BATTERY HOLDERS FOR 3V OR 4.5V SET-UP NOW INCLUDES INNER-SPINNER MACHINED-ALUMINUM 3/4 DIAMETER TOP-CAP WITH BOSS AND SET SCREW FOR MOTOR!
NOW WITH EXTRA PINSTRIPE AND EXTRA HOLOGRAM ROUND LABEL, BOTH 1" AND 3/4", SO YOU CAN MAKE AT LEAST ONE MISTAKE ON EACH! General Sizes of the assembled kit are in the listing picture of the MoPop Museum Prop.
Build process pictures, display stand pictures and, finished scanner pictures, are informational and not a part of sale. INCLUDED IN THIS KIT: Black Body hard anodized. 259 inches (for 7mm push button), 3 holes. 059 inches opposite for air release (breaks vacuum and allows cap to seat and remove) OR adding sound.
Clear interior body cavity is 1.88 inches diameter x. 98 high with cap installed. A Lota space for a sound board that you provide. Body Cap; machined aluminum with 3/8 motor hole and neoprene O-Ring and O-ring groove for securing and removing top FROM BLACK BODY and. A Groove for 1 inch outer fixed acrylic tube to seat into.
Anodized aluminum is non conductive on the surface so this kit has few problems with internal short circuits now matter how good or poor your personal prop skills may be. Bottom Plate; laser and machine engraved, suggest red-dots enamel, red-triangle enamel, white bars enamel, OR flip over for orthodox TOS buffs who prefer a plain bottom. Outer Acrylic one inch diameter and machined to correct height. Inner acrylic 3/4 inch diameter and machined to correct height. Custom Machined aluminum 3/4 inch inner-spinner-cap with motor boss and set screw included!
Three Red pinstripe for 3/4 acrylic. Three Round 3/4" hologram stickers AND Three Round 1" silver stickers for 3/4 diameter inner-acrylic-spinner. Black top push button momentary switch (suggest nut & washer be painted black by builder, I discard the washer). Motor DC 3.5 to 4.5 volts at correct 300 RPM for Star Trek with brass gearbox and flat spot on shaft (NEWLY ADDED) comes with pre-soldered leads.Motor does project-down into clear inner cavity of Black Anodized Body by 3/16 inches (nominal) at 3/8 inches diameter. Three LR44 Battery Holders as shown (NEWLY ADDED) for 3V or 4.5V set up, also a new 3 battery LR44 holder is now aka the white one. The item "Star Trek TOS, KIT Medical Scanner, Screen Accurate, Black Anodized Aluminum" is in sale since Monday, March 8, 2021.
This item is in the category "Collectibles\Science Fiction & Horror\Star Trek Collectibles\Other Star Trek Collectibles". The seller is "susannetrek" and is located in Sarasota, Florida. This item can be shipped worldwide.